SOLUTION: runs contrary to common knowledge, but what ultimately helped was:

• INCREASING print speed. The usual recommendation is the slower the better, but at that point, there’s no pressure control over the filament
• ENABLING retraction. Again, usual rec is to disable it for flexibles but turns out it alleviates too much backpressure which leads to filament buckling in the extruder

Also printing hotter than mfg recommends: I printed at 260 (10C over recommended maximum).

Thanks to u/Over_Pizza_2578 for pointing me to the right - opposite to everything else - direction.

I have absolutely no idea how Brave got the reputation it has. It’s business model is disgusting and extortionate, it’s like paying for warez. Been clear as day since day one.

For me the responsivity of Klipper UI was reason enough. Octoprint is unbelievably slow on the same hardware. The other thing was ease of configuration - no firmware compilation and flashing necessary. And the third is the actual printing performance - Octoprint has a really bad implementation of the actual print data transfer, and the serial interface routinely chokes on fine data such as arcs. That never happens with Klipper, even at much, much higher print speeds.

She does ❤️ thanks :)

Exactly :)

My kitted out Ender 3 with pink ABS accessories I have added over the years. I like the black/pink color combo.

Again?

Yes, sure. I meant things like employment, quality of output

True but that doesn’t keep it from screwing a lot of things up.

How does that work? IF (VPN detected) THEN (fail)? Do apps even have access to that information?

Or maybe they have mandatory geolocation, compare that with IP location and if it doesn’t match (=VPN), then refuse to work?

Mastodon is almost all 40yo white guys. Source: am one