I print in my basement and keep a dehumidifier on 35%. Right now it’s down to 20% because winter. I have a dryer and will usually dry out a new roll. But many times I’m lazy and leave them on the spool and they usually print just fine.
You must log in or # to comment.
Stuff that’s in use I try to keep inside the enclosure, no humidity control in my garage so at the whims of humid continental climate, gets nasty in the summer. I keep things vac sealed with silca gel for long periods and print from dry boxes or enclosure mounts to take advantage of the lower humidity while printing.
Working on a powered dry box using solid state dehumidifiers like used in this, hope that’ll help with humidity issues.
Some filament isn’t super sensitive, my experience pa6>petg>abs=pla.
My printer and filament live in my basement. We have a dehumidifier down there set to 55%. Some filament spools take a year plus for me to go through and I’ve never dried any of them. I have not noticed a meaningful change in print quality, but I also rarely go from an old to a new spool of the same material back to back.
I printed mostly PETG and ASA with some PLA thrown in.
I store all my filament in ziplock bags with some 3a molecular sieve - even after 2 years in 45-65% humidity at 21C room I don’t have to dry PETG.
I do about the same. Usually I’ll throw the silica packets that come with the roll in my filament dryer and then in the bag.
Check silica packet effectiveness below 50% humidity… It’s not great. Molecular sieve on the other hand has no problem getting humidity below 5%. I managed to buy a 10kg bucket of 3A sieve for about $120 and it’s going to be enough for many years.
