Edit: Deleting this post. It’s starting to get controversial, but that’s OK. Not what I planned on, but whatevers.
deleted by creator
This is legit cool, but the fact that you’re doing this on a garage floor instead of in a hood or outside is terrifying
deleted by creator
These companies barely release data sheets for pla filaments. I wouldn’t boil anything with resin in it in any garage for any amount of money.
https://www.elegoo.com/blogs/3d-printing/elegoo-resin-sds
Isopropylidenediphenol, aka bpa
Edit, I just keep finding more shit in the sds, trimethylcyclohexyl acrylate, butyl acrylate, repeated exposure can lead to lung damage
Brother, I hope you’re in one of those Andromeda Strain full body suits.
deleted by creator
What I do is just expose the dirty isopropanol to sun or UV in general - the resin will precipitate. Then just filter it out and you have clean isopropanol.
deleted by creator
I see, to be honest I have not checked how clean it actually is. It is visually transparent, as opposed to the used one, but you are probably correct.
Have you tried using typical water filters and letting the alcohol filter through? I suppose it wouldn’t remain as pure as distilling, but might be mostly reusable while posing no immediate fire hazard.
deleted by creator
Yo, this thread caught my eye, but because it’s deleted, it’s unclear exactly what it’s about. Can someone summarize exactly what I’m to avoid?
A BIT?!!! oh fuck no
deleted by creator
