Hi folks. I obtained a pre-owned Anycubic Vyper. Alas, every print features defects in the surface as shown in the picture. It occurs in any type of material. Does anybody know the source of this type of defects?

  • sobchak@programming.devEnglish
    5·
    3 months ago

    I got results kinda like that before when I tried a Volcano on an old Bowden style printer and printing wet PETG… Tons of oozing.

    • FUsername@feddit.orgOPEnglish
      2·
      3 months ago

      Well, the PETG is brand new and I use a heated chamber for the filament, so I really hope this is not the case. But as the setup sits in a basement, I’ll try to check that, too.