acargitz@lemmy.ca to 3DPrinting@lemmy.worldEnglish · 1 month agoAny ideas what I did wrong here? What caused these blobs?lemmy.caimagemessage-square6linkfedilinkarrow-up110arrow-down11
arrow-up19arrow-down1imageAny ideas what I did wrong here? What caused these blobs?lemmy.caacargitz@lemmy.ca to 3DPrinting@lemmy.worldEnglish · 1 month agomessage-square6linkfedilink
minus-squareacargitz@lemmy.caOPlinkfedilinkEnglisharrow-up3·1 month agoElegoo Centauri Carbon, and I’m using Orca on Linux.
minus-squareeinkorn@feddit.orglinkfedilinkEnglisharrow-up2·1 month agoHave you completed the calibration steps in Orca Slicer?
minus-squareacargitz@lemmy.caOPlinkfedilinkEnglisharrow-up2·1 month agoNope, didn’t know I had to, I’ve had multiple prints succeed previously, but also clogs often enough to be annoying, so maybe that’s it. Thank you very much for the pointer, let’s hope it’s what was missing.
Elegoo Centauri Carbon, and I’m using Orca on Linux.
Have you completed the calibration steps in Orca Slicer?
Nope, didn’t know I had to, I’ve had multiple prints succeed previously, but also clogs often enough to be annoying, so maybe that’s it. Thank you very much for the pointer, let’s hope it’s what was missing.