Oh, I’m a-doin’ it.
This part is actually slightly outside the “safe print zone” dashed lines on my build plate. I put down like half a can of hairspray on it right before the nozzle descended. Wish me luck.
You must log in or # to comment.
Good luck
Is this a 2d printer next to the 3D one?
Yeah, I keep all my printers in one place.
Well, except for the laser engraver. I guess you could consider that a “printer.”
huh, hair spray, makes sense
i’ve been using an FDM-specific spray, but I bet hair spray is more cost effective
There are some materials where that’s probably a better idea. Polycarb or Nylon leap to mind. But for PLA, PETG, ABS/ASA, etc. I’ve found that hairspray works just fine. I’ve been doing it for years.
The cheapest you can get. Maximum sticky, minimum scents and aloe vera or whatever the fuck else. I use Aqua Net.
Hope you did enough bottom wall layers. The big tray looks like it could be a bit flimsy.
Three all around. This is not meant to bear any weight. It’s a work tray for fiddling around with knives and other small assemblies wherein I’m tired of having screws roll away and having to chase them on the carpet.
Poor a little silicone in afterwards for a soft, squishy bottom that will make grabbing small parts easier.
