Hahahahaha didn’t even realize the typo. But yea I made them maaaaad!

Upsetting the mirrors did it for me.

I will give this a shot when I get back home and report back

Done. I uploaded a screenshot

OnlyOffice has fantastic support for Microsoft originated documents. I typically use the Flatpak version. The look and feel is very similar to the office suite so you should be “right at home”.

Something else to check is your infill percentage. Make sure you don’t have it at 100% (unless you absolutely need to build something completely solid). Another thing to check is your print speed. Too low and it will take a decade to print something simple. Too fast and it cause your print to fail. At this point we will all be throwing spaghetti against the wall. Can you share a screenshot of your settings?

Took me a bit to see these patterns/packages (mainly because I’ve never used Yast). I can see these patterns and the software that they install, is it better to use Yast to remove the packages and the patterns and mark them as “Don’t install that sh.t again” or through cli?

Thank for the dup vs up tip. I found it odd having to do both.

Did not find any meta packages installed

Okay so I ran sudo zypper search pattern* and found one called patterns-games-games and patterns-office-office. I assume these are the “patterns” responsible for installing stuff like Kmines, KSoduku, LibreOffice, etc which I don’t want. I also assume I can run sudo zypper remove patterns-games-games to remove it all? Or do I need to remove the packages individually and then remove the pattern?

Well when I boot after reboot, I see updated software packages and running uname-a shows the new kernel zipper said it was going to install. Based on that I assume that the answer would be no

The council members would like to “speak to you” about a recent “developments” we’ve been made aware of. We assure you, nothing will happen to you…

I’m not the one saying “FreeCAD sucks”, its sprinkled throughout this entire post. My comment/questions was related to saying “okay so if FreeCAD “sucks” and fusion360 is pulling the rug on us, what else is out there that is comparable and as useful as fusion360”

Okay so Fusion360 money grab, FreeCAD bad alternative, what’s left (legitimate question)???

Wooahh this is next level!

I’ll check out that series. Need a bit of a jumó start to get started.

Say I have an stl of car. I would like to take that stl and import it into , push some buttons and sprinkle fairy dust to create a wireframe of said car (like in the link provided in the post) the export that wireframe to an stl, svg, or whatever I can to be used on my laser or printer.

Alternatively, if such “import” feature does not exist, then use to manually create the wireframe of a car then export it the same way as above.

Okay I’ll check this out. I’ve not touched Blender out of intimidation. Every time I install it, I’m just overwhelmed with the insane amount of buttons and levers you can pull or push.

I guess it’s time to sit down, bite down on a stick and do it.