One body per sketch was always a deal breaker for me, so it’s good to hear that limitation is gone.

Do you know if sketches are still required to represent a single continuous face? For example, 3 concentric circles would not be allowed because it is ambiguous which parts are “surface” and which are “holes”. F360 doesn’t impose this limitation because it allows you to select individual sketch faces to move into 3D space, whereas FreeCAD considers that a single operation on the entire sketch.

Hmmm… that page doesn’t mention the free “personal use” license for hobbyists.

https://www.autodesk.com/products/fusion-360/personal

^ This page still exists, and doesn’t mention it is going away, so maybe there is still hope.

tl;dr It was a bug. It is fixed in 17.1.

In general, if you think that the government should have a new or increased power (in this case deciding the “truth” of what people say online) you must consider how this power will be used when a government you do not agree with is eventually elected. They will still have that power, so how do you think they will use it?

No worries. I was really hoping you were fed up with an Ender 3 just like I am 🤣

I’d very much like to see a follow up to this after you have a few prints under your belt. What you like or don’t like, or compare to other printers you’ve had.