• regrub@lemmy.world
    link
    fedilink
    English
    arrow-up
    118
    arrow-down
    1
    ·
    2 years ago

    Most high-quality LiPo-powered devices already do this at the hardware-level. The 100% level you see on the software is usually 80% actual charge on the battery.

      • Zak@lemmy.world
        link
        fedilink
        English
        arrow-up
        41
        arrow-down
        1
        ·
        2 years ago

        For Android, there are a multitude of apps, such as Wattz that will tell you the actual voltage of the battery. Full may be 4.2V or 4.35V depending on the chemistry used. ACCA (root required) will let you limit charge rates and stop charging at a certain percentage.

        Staying under 4 volts (around 60% for most phone batteries) will vastly extend battery service life. 80% is a bit less extension, but still far better than charging to 100%.

        • ji17br@lemmy.ml
          link
          fedilink
          English
          arrow-up
          3
          ·
          2 years ago

          Not sure how accurate this would be as charging is not 100% efficient. Also the amount of power the phone uses while charging would have to be taken into account as well.

      • Bocky@lemmy.world
        link
        fedilink
        English
        arrow-up
        1
        ·
        2 years ago

        mAh are a terrible way to measure capacity, look for watt-hours instead. You need to know the voltage for it to be a relevant measurement

    • Otter@lemmy.caOP
      link
      fedilink
      English
      arrow-up
      4
      ·
      2 years ago

      Yea that’s what I’ve heard, and I personally keep stuff plugged in

      It was a recent article by iFixit, so I thought I’d share it ¯\_(ツ)_/¯